Cho, KS Choi, HJ Lee, JG Kim, YW 2024-01-21T16:12:43Z 2024-01-21T16:12:43Z 2021-09-03 1999-01 1013-9826 https://pubs.kist.re.kr/handle/201004/142627 In situ-toughening of silicon nitride can result in dramatic improvements in toughness and R-curve properties. However, the improved toughness is offset by a notable reduction in strength. This problem can be overcome through the fabrication of a layered ceramics. By placing a thin layer of high-strength material on the surface of a high-toughness body, the toughness and flaw tolerance of the whole body can be maintained without sacrificing strength. In this study, alpha-Si3N4 and beta -Si3N4 seeded alpha -Si3N4 were used for the surface layer and inner layer, respectively. The inner layer was formed by isostatic pressing and subsequent annealing, and the surface layer was coated on it by controlled dipping. The surface layer consisted of relatively fine beta-grains with duplex microstructure, while the inner layer consisted of relatively coarse beta -grains with duplex microstructure. The layered material showed stronger R-curve behavior and better flaw tolerance than monolithic materials. The processing and mechanical properties of these materials were discussed. English TRANS TECH PUBLICATIONS CRACK-GROWTH-RESISTANCE FRACTURE-TOUGHNESS STRENGTH ALUMINA Layered silicon nitride ceramics with improved flaw tolerance Article 10.4028/www.scientific.net/KEM.159-160.245 1 NOVEL SYNTHESIS AND PROCESSING OF CERAMICS, v.159-1, pp.245 - 250 NOVEL SYNTHESIS AND PROCESSING OF CERAMICS 159-1 245 250 scie scopus 000080750000036 2-s2.0-0040316910 Materials Science, Ceramics Materials Science, Composites Materials Science Article; Proceedings Paper CRACK-GROWTH-RESISTANCE FRACTURE-TOUGHNESS STRENGTH ALUMINA silicon nitride R-curve layered ceramics dipping