Evaluation of a MF membrane system composed of pre coagulation-sedimentation and chlorination for water reuse

Abstract

In this research, we investigated the variation of transmembrane pressure and permeate water quality in pre-coagulation and sedimentation with iron based coagulant, and chlorination of feed water for PVDF (Polyvinylidene fluoride) based MF membrane filtration. NaClO was fed to the membrane module at a dosage of 0.5 mg/L and maintained during filtration. To observe the effect of raw water, three types of raw and processed waters, including river surface water, coagulated water and coagulated-settled water, were employed. In the case of river surface water, the transmembrane pressure increased abruptly in 500 hours operation. On the contrary, no significant increase in transmembrane pressure was observed for coagulated water and coagulated-settled water for 1200 hours operation. The turbidity of permeate was lower than the detection limit for all applied waters. The removal efficiency for humic substances in coagulated water-And coagulated-settled water was approximately ten times higher than that in surface river water. And, the removal efficiency for TOC and DOC was approximately two times higher than that in surface river water. From the results of the operation, it can be observed that it is possible to maintain stable operation at 0.9 m(3)/m(2)-day filtration flux through a combination of pre-coagulation and pre-chlorination. However, the water quality of permeate was the best when the pre-coagulation-sedimentation process was combined with pre-chlorination. With respect to fouling reduction and operation efficiency increase in membrane filtration, the pre-coagulation/sedimentation process is a promising alternative..