3D optical microstructure fabrication and its bonding to micro IR detector using elastomeric polymer

Abstract

This paper describes polidimethylsiloxane(PDMS) based bonding for assembly of microstructure device, an UV lithography applications for fabricating a 3-dimensional (3D) feed-horn-shaped structure mold array, and obtaining parallel light by using a mirror-reflected parallel-beam illuminator (MRPBI) system. A 3D feedhorn-shaped micro-electro-mechanical systems (MEMS) antenna has some attractive features for array applications, which can be used to improve microbolometer performance and to enhance the optical efficiency for thin film transistor-liquid crystal display (TFT-LCD) and other display devices but currently, MEMS technology has faced many difficulties in the fabrication of a 3D feed-horn-shaped MEMS antenna array itself. The purpose of this paper is to propose a new fabrication method to realize a 3D feed-horn-shaped MEMS antenna array by using a mirror-reflected parallel-beam illuminator (MRPBI) System with a very slowly rotated, inclined x-y-z stage. With a conventional UV lithography apparatus, it is very difficult to fabricate high-aspect-ratio structures (HARS) because a typical UV lithography apparatus cannot produce perfectly parallel light. From a theoretical analysis, a columnar illuminator over 6 In in height is required to achieve parallel light, but generally a laboratory height is not 6 m. Also, a novel method of lithography was tried to make a 3D structure array by exposing a planar wafer to the generated parallel light and rotating an inclined x-y-z stage at an ultra-slow rate. An optimization of the 3D structure array can be achieved by simulating a 3D feed-horn MEMS antenna. The feasibility of fabricating both a 3D feed horn MEMS antenna and assembly of detector with 3D feed-horn MEMS antenna was demonstrated. As a result, it seems possible to use a 3D feed-horn-shaped MEMS antenna to improve microbolometer performance and to fabricate several optical microstructure applications.